+86-13292700517
0102030405
SM-10 Double Facer
Structural features
1. Heating plate surface by grinding treatment, hot plate width 600mm, a total of 9-16 Heating plate and cooling 5 m. Heating plate with a container board production, in line with national standards for a class pressure vessel, with pressure vessel certificate and inspection certificate.
2. Hot plate with intensive gravitational roll structure. Roll adopt pneumatic lifting.
3. Heating plate heat transfer pipe temperature control sub-four-segment, with a temperature display.
4. On cotton use two-cylinder S type cotton belt with the tension device.
5. Lower belt adopt pneumatic tension.
6. Drive roller coated with attached wear-resistant rubber ,showed a herringbone structure,With a high, ensure smooth cardboard output.
7. Main drive motor for frequency conversion motor,low-speed torque,wide speed range ,reliable, and easy maintenance.
8. Hot plate internal for partition isolation structure,s-shaped flow of steam,Steam, water separation function significantly improves the utilization of steam.
Technical parameters
1. Temperature requirement: 160—200℃; Steam pressure:0.8-1.3MPa
2. Air source pressure: 0.6—0.9MPa
3. Cooling stereotypes length: 5m; Heating plate quantity:14 pieces 5 pcs shoes
4. Hydraulic system pressure: 6---8MPa
Roller diameter parameters
1. Upper drive rubber roller diameter: 475mm; Lower drive rubber roller diameter : 350mm; Wear rubber Outsourcing
2. Former follower with roller diameter:215mm; Back setting belt driven roller diameter:176mm
3. Platen roller:70mm; Setting roller diameter:86mm
4. Upper belt tension roller diameter:155mm; Upper roll diameter with detuning:124mm
5. Entrusted with the roll diameter lower belt:130mm
Note: All the roller surface after grinding are hard chrome plated.
Power motors and electrical parameters
Main drive motor power:22Kw 380V 50Hz Continuous (S1) working standard